Publicité
④If the cables/wires you want to strip are hot,also can not get the copper
wires stripped out.
4.If the cables/wires were blocked in the axises,please check below
points:
① If the springs on the press wheels are too tight,loose them.
② There are too much oil on the cables/wires,please wipe it.
5.If see the blades tilted :
①Check whether the center adjuster was loosed.
②centering adjustment and adjust the screws of two sides of it.
Make sure the cables/wires'diameter are similar with the feeding
holes ,large cables/wires in large feeding holes,small cables/wires in small
feeding holes,flat cables/wires in flat feeding holes.
This product comes with the following items: manual, gloves, hand wheel and
allen key
Technical Support and E-Warranty Certificate
www.vevor.com/support
Publicité
