Publicité
ZEPHYRONLINE.COM
Possible Problem
The appliance does not
operate.
The appliance is not cold
enough.
The appliance turns on
and off frequently.
Refrigerator Freezer Drawers Use, Care, and Installation Guide
Possible Cause
Not plugged in.
The appliance is turned off.
The circuit breaker tripped or has a blown
fuse.
Sabbath mode may be enabled.
Temperature control setting is too high.
External environment may require a higher
setting.
The drawer is opened too frequently or for
long periods of time.
The drawer gasket is not sealed properly.
Demonstration mode may be enabled.
The unit does not have sufficient ventilation.
The cooler has restricted air flow due to too
much storage.
The unit was recently installed.
The unit was recently relocated.
Incorrect preset temperature setting.
The unit was recently plugged in or power was
recently restored.
The room temperature is hotter than normal.
The drawer gasket is not sealed properly.
The drawer is opened too frequently or for
long periods of time.
The unit does not have sufficient ventilation.
The drawer is not closed completely.
Troubleshooting
Solutions
Ensure the appliance is plugged in and the
power outlet has power.
Turn on the appliance.
Replace the broken fuse or reset the
breaker.
See the Operating Your Appliance section
and verify if Sabbath mode is disabled.
Adjust the set temperature.
Keep the appliance away from sunshine or
other heat sources.
Close the drawer tightly and do not open
the drawer too frequently or for a long
period of time.
Ensure the drawer gasket is not loose.
See the Operating Your Appliance section
and verify if Demonstration mode is
disabled.
Read and follow the "Installation
Clearance Requirements" in the Installation
Instructions section.
Open space in the cabinet to allow air flow.
It may take a few hours for each zone to
reach the desired temperature.
If the unit was stored on its side, shift the
unit to stand upright for 24 hours before
powering on. If it was stored for a long
period of time, it will take time for the unit
to reach set temperatures.
Make sure the correct preset temperature
setting is selected. Pantry mode would be a
lot warmer than Freezer mode.
The unit may take up to 24 hours to reach
set temperature.
Run the refrigerator at the appropriate
ambient temperature.
Ensure the drawer gasket is not loose.
Close the drawer tightly and do not open
the drawer too frequently or for a long
period of time.
Read and follow the "Installation
Clearance Requirements" in the Installation
Instructions section.
Make sure the drawer is completely closed.
27
Publicité
