Publicité
EN
MAINTENANCE
•
Handle measuring devices with care.
•
Clean the device after every use with a soft cloth.
If nessesary, dampen the cloth with water.
•
If the instrument gets wet, clean it and dry it
carefully.
•
Only put the laser away when it is completely dry.
•
Remove the batteries and rechargeable batteries
when switching off the aser for a long time.
•
Do not use solvent to clean the laser.
•
Only transport the laser in its original case.
The laser is not watertight or airtight. Do not
get it wet, as this may damage the internal
circuits. Do not leave it in direct sunlight or
exposed to high temperatures. The laser body and
some internal parts are made of plastic and can warp
at high temperatures. Do not store the laser in a very
cold environment, as this can cause condensation to
form on the internal parts when the laser is warmed
up. This can mist up the beam windows and cause the
internal circuit boards to rust.
POSSIBLE ERRORS
If the measurements calculated by the laser are incor-
rect, this could have been caused by:
•
Using the laser near to plastic or glass windows
(may give false information).
•
A dirty or obstructed beam window.
•
A slight movement of the device. If this is the
case, check the precision of the device once
more.
•
Signifficant temperature diffrences: if the laser is
used in a cold environment after being stored in
a warm environment, wait a few minutes for the
laser to reach room temperature before carrying
out any measurements.
20
WARRANTY AND RESPONSIBILITY
The device has a four-year warranty. This warranty
does not cover breakdowns or faults which may have
been caused by:
•
Incorrect use of the device.
•
Non-respect of the instructions described in the
usermanual.
•
Offcuts, poor handling, use of unsuitable batter-
ies, poor electrical connections etc.
Repairs made other than by our factory, our service
centres or authorized service stations relieve our
company of further liability under this guarantee. This
warranty is made expressly in place of all other war-
ranties, expressed or implied, with respect to quality,
merchantability, or fitness for a particular purpose.
THE USER MUST CHECK THE DEVICE
REGULARLY AND BEFORE CARRYING OUT
SUBSTANTIAL WORK.
LEVELFIX company shall accept no responsibility for
problems regarding the construction, installation,
manufacture or assembly which may result from
a machine failure due to poor maintenance of the
device or hazardous connections to other devices.
BATTERY CHARGE
This laser operates on a Li-ion battery.
If the voltage is too low, the indicator light 9 (fig. 2)
starts flashing and the battery needs to be charged.
Open the rubber cap at the top of the battery and
insert the charging plug. The blue LEDs will now flash
until the battery is fully charged.
The battery can be charged while the instrument is
in use.
Publicité
