Publicité
When operating your appliance for the fi rst time, there is a required burn-in process that cures materials used
to manufacture the fi replace that may emit both vapors and an odor. These are normal when operating a new
appliance for the fi rst time. Ensure adequate air circulation is provided during burn-in process, if this was not
completed by the installer during installation.
2.1
using your appliance
To turn the appliance on:
A
Turn the on/off switch on.
B
After 3-5 seconds, the control will start a spark at the pilot, light the pilot and then the burner. The spark
period will last 60 seconds, or until the pilot has lit.
C
When used for the fi rst time, if the burn-in process was not completed by the installer; run appliance
continuously for 4 hours (burn-in).
D
Turn the appliance off. Wait until appliance is completely cool before moving to the next step.
E
Remove the safety barrier and fi rebox glass door. Clean fi rebox glass door (see "maintenance" section).
Replace fi rebox glass door and safety barrier.
For more detailed information, see your installation manual or contact your authorized dealer.
2.2
on/off components
|
Wall switch
(Not supplied)
Batteries must be disposed of according to the local laws and regulations. Some batteries may be
recycled, and may be accepted for disposal at your local recycling center. Check with your
municipality for recycling instructions.
|
USB Power Pack
(Not supplied)
2.0 operating your appliance
operating your appliance
|
Receiver
(Optional)
ON
OFF
|
Remote control
(Optional)
W415-3038 / 05.05.21
EN
|
7
Publicité
