Publicité
EN
1、
Open the stop valve
to let water in
4、Screw in the adjustment levers
of the
control plate
7、 Make sure every xing part is
in place and adjustment levers of
the control plate button work well
OPEN
2、Take the cistern's plate
from the cistern
2
1
button
1
Leave no space between
the shaft shoulder and
the back surface of the
control plate base
5、Adjust the levers to a
right position
8、Fix the control plate as
shown in the picture
2
out
3、Fix the control plate base
fasten the screw
less than 25 N.m
6、Install the block as
suggested
9、Check the water ush by
pressing the half- ush and
full- ush buttons
，torque force
Publicité
