Diamond E7/4VCF7-N Manuel D'installation page 42

TROUBLESHOOTING
Whenever the appliance does not work properly, try to solve the less
serious problems using this table.
FAULT
The appliance does not
turn on.
The light indicators do
not turn on.
The cooking compart-
ment is stained.
The appliance does not
heat up
If the problem cannot be resolved, turn the appliance off, disconnect it
from the electrical mains and shut all the supply valves. Then contact au-
thorized customer service.
THE PRESENT MANUAL IS PROPERTY OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
POSSIBLE CAUSE
The master switch is
•
not connected.
The residual current
•
device or circuit brea-
ker has tripped.
Quality of the water.
•
Ineffective detergent.
•
Insufficient rinsing.
•
Damaged
•
components
- 19 -
MAINTENANCE
INTERVENTION
Connect
•
switch.
Call technical authori-
•
zed service
Filter the water (
•
chnical authorized ser-
vice)
Use the recommended
•
detergent.
Rinse once again.
•
internal Call technical authori-
•
zed service
the master
Call te-