Diamond E7/4VCF7-N Manuel D'installation page 38

the highest setting for 30-40 minutes with
the door closed. This burns any oily resi-
due that could release unpleasant odours.
SWITCHING ON/OFF / see SECT.
IMAGES - REF. h)
To begin cooking operations, follows
the below instruction:
HOTPLATE / 1. Turn the knob to set
the correct temperature (Fig.1). Green
indicator switch-on and blinks regular-
ly (Fig.1 A).
2. Turn the knob in "Zero" position (Fig.
1 B) to switch-off the heating generator.
Hotplate heating speed is set by
turning the knob (Position 0-3).
Position 3 is the maximum hea-
ting speed.
The sensor (red LED on the
glass hob) signals the presence
of heat of the associated plate
(front / rear, T ≥ 60°).
To activate the second element,
turn the knob clockwise as far
as it will go, and ignite (Fig. 1/C).
OVEN / 1. Turn the knob to adjust the
cooking temperature (Fig. 2 OVEN).
2. When the green light is on it means
operation is in progress (Fig. 2 A)
When the yellow light is on it means
heating is in progress (Fig. 2 B).
3. Turn the knob to "Zero" (Fig. 2 C) to
stop heat generation.
The oven cooking temperature
is set by turning the thermostat
knob (See indications on knob).
To ignite only the upper element,
turn the knob to the relevant
symbol (Fig. 2/D).
THE PRESENT MANUAL IS PROPERTY OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
INSTRUCTIONS FOR USE
LOADING / UNLOADING THE PRO-
DUCT / see SECT. IMAGES - REF. i)
The amount of the product insi-
de the container must not exce-
ed 3/4 its capacity.
Use suitable pots and pans
(e.g. stainless steel ones with
flat bottom).
1. Place the container in the middle of
the hotplate (Fig. 3).
When cooking is over, remove the con-
tainer from the hotplate and put it in a
place prepared beforehand.
2. Open the oven door to load it.
Put the container in the cooking com-
partment in the middle of the grid (Fig.
4). Close the oven door.
When opening the doors, step
to the side of the appliance to
avoid direct heat.
When the product is cooked, unload
it and put it in a place prepared befo-
rehand.
After the product has been unloaded,
load it once again or else perform the
operations described in "Deactivation".
DEACTIVATION / At the end of the
work cycle, turn the knobs on the ap-
pliance to "Zero".
The appliance must be cleaned
regularly and every incrustation
or food deposit removed. See
chapter: "Maintenance".
If present, the indicator lights
must be off at the end of the
work cycle.
Check the cleanliness and hygiene of
the appliance. See "Maintenance".
Close the network locks upstream the
appliance (e.g. Gas - Water - Electric).
- 15 -
7.