Diamond E7/4VCF7-N Manuel D'installation page 40

In case of doors, need to disas-
sembled before (hinges and fixing).
DAILY CLEANING OF ALL
STEEL COMPONENTS
Use a standard sprayer
to apply the liquid deter-
gent on the whole surface
of the cooking compart-
ment and, using a non-a-
brasive sponge, clean the entire surfa-
ce thoroughly by hand.
When finished, rinse the cooking com-
partment abundantly with tap water.
When these operations have been
performed successfully, dry the cooking
compartment carefully using a non-a-
brasive cloth. If necessary, repeat the
operations described above for a new
cleaning cycle.
DAILY CLEANING OF ALL GLASS
COMPONENTS
Wait for the equipment
cooling.
Apply a suitable deter-
gent on the surface and
clean with care using a
damp cloth. Wipe the cooking area by
a not abrasive cloth. Repeat this ope-
ration, if necessary.
DAILY OVEN CLEANING
Depending on the ap-
pliance, remove: grills,
trays or other objects re-
moved from the cooking
compartment.
Heat up the cooking compartment for
about 20'. Open the door to let the co-
oking compartment cool off for a few se-
conds. Use a standard sprayer to apply
the liquid detergent on the whole surface
of the cooking compartment and, using
a non-abrasive sponge, clean the entire
surface thoroughly by hand.
When finished, rinse the cooking com-
partment abundantly with tap water.
When these operations have been
THE PRESENT MANUAL IS PROPERTY OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
performed successfully, dry the cooking
compartment carefully using a non-a-
brasive cloth.
If necessary, repeat the operations de-
scribed above for a new cleaning cycle.
Clean the parts previously removed from
the cooking compartment (grills, trays
and other removable objects) with deter-
gent and tap water, rinse them carefully
and dry them before putting them back.
In order to eliminate all humidity, once
routine cleaning has been finished, turn
the appliance on and run it at minimum
for approximately 5' and then turn it back
off (see procedure Switching On/Off).
CLEANING FOR PROLONGED
DEACTIVATION /
To conclude the operations see chap.
5 / Operations for commissioning /
Prolonged decommissioning.
For glass components, apply with
a soft cloth a layer of protective
wax specific for the material.
Air out the appliances and rooms
regularly.
SUMMARISED TABLE /
OPERATION - FREQUENCY
Before proceeding with the ope-
rations, see chapter 2 "Tasks and
qualifications"
Should a problem occur, the ge-
neric operator performs the first
search and, if qualified, elimina-
tes the cause of the problem and re-
stores the appliance correctly.
If the problem cannot be resol-
ved, turn the appliance off, di-
sconnect it from the electrical mains
and shut all the supply valves. Then
contact authorized customer service.
The authorized maintenance te-
chnician intervenes when the
- 17 -
MAINTENANCE
8.
EN