Changing The Basic Settings; Cleaning; Ceramic; Hob Surround - NEFF T16BT 6 Série Mode D'emploi

Cleaning

en

Changing the basic settings

The hob must be switched off.
Switch on the hob.
1.
Within the next 10 seconds, touch the
2.
4 seconds.
appears and
™‚
display.
Touch the symbol repeatedly until the desired
U
3.
indicator appears.
Set the desired value using the twist knob.
4.
Touch the U symbol for 4 seconds.
5.
The setting is activated.
Switching off
To exit the basic setting, switch off the hob with the
main switch and make new settings.
40
symbol for
U
lights up in the hotplate
‹
DCleaning
S uitable maintenance and cleaning products can be
C l e a n i n g
purchased from the after-sales service or in our e-Shop.

Ceramic

Clean the hob after each use. This will prevent spills
from burning onto the ceramic.
Only clean the hob when it has cooled down sufficiently.
Use only cleaning agents which are suitable for glass
ceramic. Follow the cleaning instructions on the
packaging.
Never use:
Undiluted washing-up liquid
■
Detergent intended for dishwashers
■
Scouring agents
■
Harsh cleaning agents such as oven spray or stain
■
remover
Abrasive sponges
■
High-pressure cleaners or steam jet cleaners
■
Ground-in dirt can be best removed with a glass
scraper, available from retailers. Please note the
manufacturer's instructions.
You can also obtain a suitable glass scraper from our
after-sales service or from the e-Shop.
Using special sponges to clean glass ceramic achieves
great cleaning results.

Hob surround

To prevent damage to the hob surround, observe the
following instructions:
Use only hot soapy water.
■
Wash new sponge cloths thoroughly before use.
■
Do not use any sharp or abrasive agents.
■
Do not use the glass scraper.
■

Twist knob

It is recommended that the touch knob is wiped with
lukewarm soapy water only. Do not use harsh or
abrasive agents. The twist knob will be damaged if
cleaned in the dishwasher or immersed in soapy water.