Publicité
3. Press
to validate settings.
WATER HARDNESS
°dH
°fH
0 – 5
0 – 9
6 – 11
10 – 20
12 – 17
21 – 30
18 – 22
31 – 40
23 – 34
41 – 60
35 – 55
61 – 98
Factory setting: H3
NOTE:
1 °dH=1.25 °Clarke= 1.78 °fH= 0.178 mmol/l
°dH: German degree
1)
Every cycle with a regeneration operation consumes additional 2,0 litres of water, the energy
consumption increases by 0,02 kWh and the program extents by 4 minutes.
Filling with salt
The salt container must be refilled when the salt warning light
1. Remove the lower basket and unscrew the cap from the salt container.
2. Place the end of the funnel (supplied) into the hole and pour in about 1,5 kg dishwasher salt.
3. Fill the salt container to its maximum limit with water.
It is normal for small amount of water to come out of the salt container.
4. Screw back the cap tightly.
5. Remove any salt that has fallen around the opening of the container and into the tub.
WARNING!
Salt is corrosive, it is strongly recommended to run a shortest program without dishes after each salt
container filling to wash away any salt that may have been spilled into the tub.
NOTE: Depending on how well the salt dissolves, the salt warning light
the salt container is filled.
°Clarke
Mmol/l
0 – 6
0 – 0.94
7 – 14
1.0 – 2.0
15 – 21
2.1 – 3.0
22 – 28
3.1 – 4.0
29 – 42
4.1 – 6.0
43 – 69
6.2 – 9.8
°fH: French degree
Regeneration
occurs every X
Display
program
sequence
H1
No regeneration
H2
H3
H4
H5
H6
°Clarke: British degree
GB-12
Salt consumption
(gram / cycle)
1)
10
5
3
2
1
illuminates.
may still be on even though
0
9
12
20
30
60
Publicité
