Rechargeable Beard Trimmer Use instructions
Only the blades can be washed under tap water. Do not immerse
the appliance into water, and do not rinse it under tap water.
Do not use abrasive or corrosive detergents to clean the appliance
and the blades.
Product description Fig.A
1. Cutting length selector
2. ON/OFF switch
3. Charging indicator
4. Blades
5. Comb attachment (1-10mm)
6. Lubricating oil bottle
7. Cleaning brush
Use instructions
Charging of the appliance
Make sure tha the appliance is switched off before charging it.
Insert the power cable in the connector found at the bottom of the appliance, and connect it to a USB plug (USB wall adapter
or PCS USB port). USB wall adapter is not included.
The charging indicator turns on, and it will stay on until the appliance is disconnected from the USB plug.
Normal charging time is 8 hours. Do not charge the appliance for a longer period of time, to avoid damaging the battery.
8 hours of charging allow up to 60 minutes of continuous use of the appliance.
To ensure maximum life of battery, we recommend the following:
Do not charge the appliance between use sessions; allow the battery to discharge completely.
Discharge completely the batteries at least twice a year (slide the ON/OFF switch to the ON position and let the appliance
run until it stops)
Important! Do not use the appliance while charging
Avoid charging the appliance in direct sunlight or close to direct heat sources.
Use of the appliance
Make sure the appliance is switched off.
Insert the comb attachment as described below, and choose the desired cutting length with the selector.
Note: the cutting length selector does not turn while the appliance is operating.
Slide the ON/OFF switch upwards to turn the appliance on, and proceed with trimming, making sure to move the appliance
against the direction of growth of the hair, and to keep the cutting head as flat as possible on the skin. Clean the comb attach-
ment and the blades after each use, to avoid clogging and consequent damaging of the appliance.
Mounting/removal of comb attachment
Make sure the appliance is switched off.
To mount the comb attachment, place the cutting length selector on "10", and fix the comb attachment to the blades as shown
in (FIG. B).
To remove the comb attachment, turn the appliance off, place the cutting length selector on "10", and gently pull upwards.
Mounting/removal of blades
Make sure the appliance is switched off before proceeding with mounting or removal of blades.
To remove the blades, apply light pressure upwards with your thumb, right on the arrow found at the back of the appliance
(FIG.C).
To mount the blades, align the ribs on each side with the guides found on the appliance, and gently press downwards until
the blades are firmly fixed (FIG.C).
Cleaning and maintenance
Make sure that the appliance is switched off, and the power cable unplugged.
Remove the comb attachment and the blades as described above.
With the aid of the cleaning brush provided, remove hair and dust found on the blades, comb attachments and appliance
(FIG.D) Rinse the blades under tap water for more accurate and thorough cleansing (FIG.E). Let dry completely before
mounting the blades back on the appliance.
Warning: do not immerse the body of the appliance in water or other liquids
Every 2-3 use sessions, it is advisable to lubricate the blades with one or two drops of oil (included)
8