Publicité
Precautions:
1. When disassembling the bezel accessories counterclockwise, avoid
applying too much force to prevent damage to the internal structure.
2. When installing the bezel accessories clockwise, ensure that the
bezel is horizontally snapped onto the watch body before rotating it to
prevent damage to the internal structure.
3. It is not recommended to wear the watch without the bezel
accessories attached, as this may scratch the skin or wear down the
internal structure.
4. The identification mark on the back of the bezel must be aligned with
the mark at the 12 o'clock position of the watch screen, and the CMF by
Nothing logo should be placed at approximately 7 o'clock before
tightening it by rotating clockwise.
5. Frequent disassembly and assembly of the bezel accessories can cause
wear and tear to the internal structure, leading to failure to tighten
or loosen, which is a normal phenomenon. Please ensure a reasonable
frequency of disassembling and assembling to extend the lifespan of
bezel accessories.
CHANGE STRAPS
To remove and replace a strap:
Please turn watch over and find the
quick-release lever — there's one on
each end where the strap meets the
frame. Slide the quick-release lever
and hold it to remove a strap from
the watch or attach a strap to the
watch.
Publicité
