Publicité
o1 INSTRUCTION MANUAL
•Before connecting the ice maker to the power source, let it stand upright
for approximately 4 hours. This will reduce the possibility of a malfunction
in the cooling system from handling during transportation.
•Clean the interior surface with lukewarm water using a soft cloth.
INSTALLATION THE ICE MAKER
•This appliance is designed to vent hot air through the front vent. This
allows for installation in a recessed or built-in application, if desired.
•Place your ice maker on a level surface that is strong enough to support
the ice maker when it is fully loaded. Remember that the unit will be
significantly heavier once it is operational and fully loaded.
Level your ice maker by adjusting the legs at the front of the ice maker.
•Locate the ice maker away from direct sunlight and sources of heat
(stove, heater, radiator, etc.). Direct sunlight may affect the finish and heat
sources may increase electrical consumption. Extreme cold ambient
temperatures may also cause the ice maker malfunction. This ice maker is
designed for installation indoors in "room temperature" ambient conditions.
•Position unit to allow free airflow through the front grille ,avoid locating the
ice maker in moist/humid areas. Too much moisture in the air will cause
frost to form quickly on the evaporator requiring frequent defrosting.
- 7 -
Publicité
