Télécharger Imprimer la page

VEVOR IMC20 Mode D'emploi page 12

Publicité

4.Align the hinge hole to the bottom hinge and install the door on the
bottom hinge, and then install the top hinge on the left. Tighten firmly. The
put the hinge cap back. The door reversing is complete.
ELECTRICAL CONNECTION
Do not, under any circumstances, cut or remove the third (ground) prong
from the power cord.
For personal safety, you must properly ground this appliance. The power
cord of this appliance features a three-prong grounding plug that mates
with a standard three-prong grounding wall outlet to minimize the
possibility of electric shock hazard from the appliance. Have a qualified
electrician check the wall outlet and circuit to make sure the outlet is
properly grounded. It is your responsibility and obligation to have a
standard two-prong wall outlet replaced with a properly grounded three-
prong wall outlet.
Always plug the appliance into its own individual electrical outlet. The
voltage rating of the outlet must match the rating label on the appliance.
This match provides the best performance and prevents overloading the
electrical circuits, which could cause a fire hazard from overheated wires.
Never unplug your appliance by pulling on the power cord.
Always grip the plug firmly and pull straight out from the outlet.
Repair or replace immediately all power cords that have become frayed or
damaged. Do not use a cord that shows cracks or abrasion damage along
its length or at either end.
When moving the appliance, take care not to damage the power cord. If
the power supply cord suffers damage, have the manufacturer, its service
agent, or similarly qualified persons replace the supply cord to avoid a
hazard.
AVOIDING USE OF EXTENSION CORDS
Because of potential safety hazards under certain conditions, the
manufacturer strongly recommends that you do not use an extension cord
with this appliance.
CONNECTING THE WATER SUPPLY
WARNING: Connect to potable water supply only.
1.Turn off the main water supply. Turn on the nearest faucet long enough
to clear the line of water.
2.Locate a 1/2" to 3/4" vertical cold-water pipe near the installation location.
The distance should be less than 9 feet.
- 10 -

Publicité

loading

Ce manuel est également adapté pour:

Imc25