Publicité
2.Connect the water supply. It is recommended you install a new water
filter at this time. It is also recommended to clean your ice maker after
long-term storage by following the instructions on pages 19 and 20.
3.Turn on the water, check for leaks.
4.Plug in the power cord to the wall outlet and turn the ice maker on.
5.Follow initial startup from page 17
MOVING YOUR ICE MAKER
1.Securely tape down all loose items inside your ice maker.
2.Turn the leveling feet up to the base (their shortest length possible) to
avoid damage
3.Tape Door Shut
4.Make sure the ice maker stays in the upright position during
transportation.
TROUBLESHOOTING
Before Calling for Service:
If the unit appears to be malfunctioning, read through the "Operating the unit"
section of this manual first. If the issue persists, check the Troubleshooting Guide
below. Some of the problems mentioned in the Troubleshooting Guide can be
solved easily without a service call.
PROBLEM
The
machine
won't
operate.
The
compressor
works
abnormally
with a buzzing
noise.
The water
doesn't feed in
after the ice
machine starts.
POSSIBLE CAUSES
The ice machine is
unplugged. The power
switch is OFF.
The ice storage bin is full of
ice.
The voltage is lower
than recommended.
The water supply is
turned off. The water
supply pipe is not
properly connected.
The water filter is not
installed or not installed
correctly
- 16 -
SOLUTIONS
Plug the ice
machine in. Turn on
power switch
Remove some ice
and lower metal
arm.
Stop the ice maker
and do not restart until
the voltage is normal.
Turn on the water
supply tap.
Reconnect the water
supply pipe.
Check that the water
filter is installed
correctly.
Publicité
