Extend The Cable; Working With The Cable Ø 8 Mm / Adapter - Wohler Rm 300 Instructions De Service

6.2

Extend the cable

Fig. 10: Release guide hose, locking bolt
marked by an arrow
Fig. 11: Push the extension cable from
the front through the unit into the protec-
tive hose.
6.3 Working with the cable
Ø 8 mm / adapter
Fig. 12: Adapter attached to the RM 300
Option 1:

If you want to extend the cable, pull the end
out of the guide hose.

To do so, pull up the locking bolt on the shaft
entrance and pull off the guide hose.

Connect the next cable piece and push the
entire cable length back into the guide hose.
Option 2:

When the cable has completely run out of the
machine, hold the end of the cable firmly or fix
it so that it cannot disappear into the pipe.

Push another cable piece from the front
through the machine into the protective hose
until only approx. 20 cm protrude from the
machine.

Connect the extension cable to the cable that
is already in the tube.
Use adapter with the 8 mm or 10 mm cable, 5 m
length, for narrow pipes or pipe bends.

To do so, pull the cable approx. 30 cm out of
the adapter magazine and push it through the
shaft.

Push the adapter magazine into the shaft
entrance and lock it with the bolt.
ATTENTION!
Due to the lower stiffness of the 8 mm cable, it
should never be used in large pipes or with hard
obstacles.
Operation
EN
33