Publicité
C O N T R O L S A N D O P E R AT I O N G U I D E
MANUALLY CONTROL FIXTURES:
1. Press FIXTURE to activate the fixture mode (indicator on).
2. Select the desired fixtures with the number buttons (1-16) and the PAGE button (PAGE A: 1-16,
PAGE B: 17-32).
3. Adjust the DMX output values by moving the faders and/or wheels. In Step 2, the user can select
fixtures individually or in groups. For example, to select fixtures 1-8, press and hold the number
button 1 and then press the number button 8. The same method applies to deselecting fixtures.
NOTE: When you press the BLACKOUT/DEL button for 2 seconds, the controller will clear the FADER
value to zero.
MOVEMENT
There are 16 built-in movements, including 9 for moving heads and 7 for LED fixtures. Before running
a movement, ensure all fixtures are correctly patched. (Refer to "01. Patch fixture.")
1. Press FIXTURE to activate the fixture mode (indicator on).
2. Select the desired fixtures with the number buttons (1-16) and the PAGE button (PAGE A: 1-16, PAGE B:
17-32).
3. Press MOVEMENT to activate the movement mode.
4. Select a desired movement using the number buttons (1-16). Movements 1-9 control the pan/tilt
movement of moving heads. "MOVEMENT RANGE" is adjustable from 0-100%; "MOVEMENT
OFFSET" is adjustable from 0-255; "MOVEMENT SPEED" adjusts the movement speed, and
"DELAY LEVEL" adjusts the delay level between fixtures. Press SWAP to switch between the
adjustable parameters. Movements 10-16, which are non-adjustable, are for R/G/B effects of LED
fixtures. You can simultaneously play at least one pan/tilt movement and one color movement for
the same fixture.
EDITING
To activate or deactivate Editing mode, press and hold REC for 2 seconds.
1. Scene Editing: You can edit channels and movements in a scene using the following steps:
•
Activate Editing mode.
•
Press FIXTURE (indicator on).
•
Select the desired fixtures with the number buttons (1-16) and the PAGE button (PAGE A: 1-16,
PAGE B: 17-32).
•
Adjust the DMX output values by moving the faders and/or wheels. You can also include
movements.
•
Press REC to prepare for saving.
•
Press SCENE, then press a number button to save the scene. There are two pages (Page A and
B) to save scenes. Once a scene is saved successfully, all the LED indicators will blink three
times.
•
Repeat steps 3-6 to edit another scene.
2. Chase Editing: You can edit channels, scenes, and movements in a chase with these steps:
•
Activate Editing mode.
•
Press CHASE (indicator on).
•
Select a number button for the chase.
•
Adjust the DMX output values by moving the faders and/or wheels. You can also include scenes
and/or movements.
•
Press REC to save the current step.
•
Repeat steps 4-5 to edit a new step. You can rotate the PAN wheel to browse all the steps. You
can also press INSERT to insert a step.
•
After editing all the steps, press CHASE, then press the number button to save and exit.
RUN SCENES
1. Press SCENE (indicator on).
2. Press the number button(s) to activate the desired scene(s).
13
Publicité
