Syncing Two Bases - TEMPUR-PEDIC ERGO Twin Long Manuel Du Propriétaire

syncing two bases (optional)
A Sync Cord is included with Twing Long and Split Cal King size bases.
The Sync Cord connects the two control boxes to a single remote for the synchronization of two bases.
STEP 1
Unplug the base(s) from power source.
STEP 2
Disconnect the battery backup box cable from each
control box or splitter cable (make note where the
cable was plugged in).
STEP 3
Connect the male end of each sync cord to control
box or splitter cable. Insert it into the same port
that you disconnected the battery backup box from
in Step 2.
STEP 4
Connect each battery backup box male connection
to the sync cord female connection (Refer to
illustration at right).
STEP 5
Plug bases back into the power source.
STEP 6
Check to ensure all cords are securely attached.
Both remotes will now operate both bases
simultaneously.
The system is now linked. Pressed buttons on either
remote will control the two bases simultaneously.
Sync Cord
Control Box 1
Battery
Backup
Box 1
PERFORMANCE NOTES
If bases become mismatched, return both bases
to the flat position to re-sync the bases.
Control Box 2
Battery
Backup
Box 2
13