Troubleshooting - Geemarc Loophear 10 Notice D'utilisation

TROUBLESHOOTING

The 'On' LED is Red
•
Charge the battery if the battery pack is used or
replace with new batteries if standard AAA batteries
are installed.
The LH10 appears not to be working
•
Make sure that the headset is securely plugged in
•
Make sure that the volume is correctly adjusted
•
Make sure that the battery is fully charged or use
good batteries.
•
Make sure the mode switch is set to MIC if using
headset/earpiece or T if using an induction loop.
The LH10 Is not charging
•
Make sure that the power supply cord is plugged in
correctly i.e. into a working wall socket and into the
LH10 Conversation Piece
•
Make sure that the battery is inserted correctly and is
of the recommended type
11