Publicité
USING THE LH10
TM
Turning the LoopHEAR
10 On and Off
Switch the headset on. Ensure the mode switch is set
to
(MIC). Roll the On/Off Volume control wheel
upwards. The On LED will display Green. Adjust the
Volume to a comfortable level by rolling the On/Off
Volume control wheel.
To turn the LH10 off or on, roll the On/Off Volume
control wheel downwards. The Green LED will switch
off and OFF will be showing on the On/Off Volume
control wheel
The LH10 can be used in rooms especially equipped
with a magnetic loop (conference ...etc) due to its "built
in T coil". Simply by setting the mode switch to T, the
LH10 will receive the emitted magnetic waves then
amplify them to your headset. You will receive all the
benefits of the "built in T coil".
9
Publicité
