Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Operation, Maintenance
There is a feature in the steering device of the Exact
Pipe Cut V1000 (Fig.A/6) which, if needed, can
improve the sawing result and facilitate to reach the
starting point.
Loosen the locking screw (Fig.O/1) with the M5 hex
key that is supplied in the handle of the pipe saw.
There is an adjustment wheel on the right hand side
of the steering device (Fig.O/2). Turn the wheel with
your finger either clockwise or counter clockwise.
The direction depends on the direction of the
misalignment. This adjustment turns the entire motor
unit in relation to the steering device. There is also
an arrow and a dial on the steering device (Fig.O/3).
These will help to gauge the extent of the adjustment.
Adjust the motor unit to the desired direction to
correct the sawing error. The arrow indicator must
move to the direction of the error. The extent of the
adjustment depends on the extent of the error, duct
diameter as well as the strength and material of the
duct wall. Tighten the locking screw after the
adjustment.
Installing and changing the
saw blade
WARNING: To reduce the risk of injury,
turn unit off and disconnect it from power source
before installing and removing accessories,
before adjusting or when making repairs. An
accidental start-up can cause injury.
Remove the power plug from the socket. Check that
the motor unit is locked in the upper position.
Remove the blade guard cover (Fig. P/1) by opening
the screw (Fig. P/2). Press the spindle-lock button
(Fig. A/11) and simultaneously rotate the blade by
hand until the spindle-lock button drops a further
distance of about 4 mm. Now the rotation of the
blade is prevented. Use the blade key to open the
blade attachment bolt. Remove the blade screw
(Fig. P/3), the washer (Fig.P/4), the blade flange
(Fig. P/5), and the blade (Fig. P/6).
Before installing a new blade, check that both blade
flange discs are clean. Place a new or sharpened
blade on the lower blade flange (Fig. P/7), so that
the marked side of the blade is facing outwards and
the arrows on the blade are facing in the same
direction as the rotation direction markings on the
inside of the blade case. Ensure that the new blade
goes right to the bottom in the lower balde flange.
Put the blade flange disc, the washer, and the
securing bolt back in place. Press the spindle lock
button and tighten the blade securing bolt. Put the
blade guard cover back in place and tighten the
Fig N
Fig O
Fig P
14
e n g l i s h
Publicité
Table des Matières
