Technical Characteristics - AEG ST 500 Instructions D'utilisation Et Consignes De Sécurité

Introduction

Technical characteristics

The voltage inverter has some technical charac-
teristics, in order to be protected and / or the
connected appliances.
Code Red LED-Display
Lights up
s cT
Lights up
0 U p®
lO uI
h I uI
Overvoltage protection:
If the input voltage is above 15,5 V (+/– 0,5 V), a
buzzing sounds, the red LED-Display
up, and HiVi is displayed on the LED-display
The voltage converter stops converting and the
external appliance will be switched off. If the
voltage drops below 14,5 V (+/– 0,5 V), the volt-
age converter starts the normal operation again.
Undervoltage protection (Battery display
function, battery protection):
If the input voltage is under 10,5 V (+/– 0,5 V), a
beep tone sounds, the red LED-display
If the input voltage is under 10,0 V (+/– 0,5 V), a
buzzing tone sounds, the red LED-display
lights up and LoVi is displayed on the LED-dis-
play .
9
The voltage converter stops converting and the
external appliance will be switched off.
If the voltage climbs above 12 V (+/– 0,5 V), the
voltage converter starts the normal operation
again.
Short circuit protection:
If the connected appliance causes a short circuit,
a buzzing tone sounds. The red LED-display
18 GB
Warning- and Protection display
In general errors are recognisable as follows:
- Red LED-display
- Peep- or butting tone
- Protection code in the LED-display
Meaning
Overload warning
Overheating warning
Undervoltage warning
Overload protection
Short circuit protection
Overheating protection
Undervoltage protection
Overvoltage protection
lights up and ShCt is indicated on the LED-
display
lights
1
Overheating protection:
.
9
If the temperature inside the device is over 60 °C,
a beep sounds, the red LED-display
If the temperature inside the device is over 68 °C,
a buzzing tone sounds, the red LED-display
lights up.
The voltage converter stops the converting, and
the external device is switched off.
If the temperature sinks below 50 °C, press the
lights up. key ON/OFF/MODE
1
re-start the voltage converter again.
1
Overload protection:
If the load is below the minimum a beep tones
and the red LED-display
If the load exceeds the maximum a buzzing tone
sounds and the red LED-display
In addition OvPr is indicated in the LED-display
The voltage converter stops converting and the
external appliance is switched off.
1
1
Type of Warning
Buzzing tone
.
9
for approx. 3 seconds to
3
lights up.
1
9
Peep tone
lights up.
1
1
lights up.
1
.
9