Publicité
AM/FM RADIO MODE
1. If the boombox is off, press the STANDBY button to turn it on.
2. Press the SOURCE button until AM or FM mode appears on the display.
3. Press
/TUN- or
manually, or press and hold these buttons to automatically seek for the
next higher or lower station.
4. Adjust the volume as needed with the VOL - and VOL + buttons.
When tuning FM broadcasts, pull out the telescopic antenna and adjust
the position to get better reception. Press FM ST/Mono to switch between
Stereo and Mono playback.
The telescopic antenna is not required for AM, as AM uses an internal
antenna. If you're listening to AM Radio and the signal is weak, adjust the
direction and position of the boombox itself to try and get better reception.
STORING RADIO STATION PRESETS
Using the PRESET button in FM or AM radio mode, up to 20 station presets
can be saved and recalled later. To store a radio station in memory:
1. Tune to the station you wish to store.
2. Press the PROGRAM button. The preset number will be displayed.
3. Press
/TUN- or
save this station under.
4. Press the PROGRAM button again to save the station.
CD PLAYBACK
1. Lift open the CD door. If a CD is already loaded in the tray, remove it.
2. Insert a CD with the label facing up.
3. Close the CD door.
4. Press the SOURCE button until the display switches to CD mode.
5. Press
ed with the VOL - and VOL + buttons.
6. Press
You can also press Folder+/10+ to skip ahead by 10 tracks.
7. To stop playing, press STOP. To pause, press
/TUN+ repeatedly to tune the desired station
/TUN+ to select the preset number you want to
to begin playing, or to pause. Adjust the volume as need-
or
to select the next or previous song/track on the CD.
–8–
Publicité
