Télécharger Imprimer la page

Pepperl+Fuchs Smart-Ex 03 DZ1 Guide De Démarrage Rapide page 6

Masquer les pouces Voir aussi pour Smart-Ex 03 DZ1:

Publicité

The power delivered by the charger must be between min 2.5 Watts required by the radio
equipment, and max 16.2 Watts in order to achieve the maximum charging speed.
"For environmental reasons this package does not include a charger. This device can be
powered with most USB power adapters and a cable with USB Type-C plug.".
If the glass breaks, do not touch the glass parts of the device or attempt to remove
the broken glass from the device. Stop using the device until the glass is replaced by
qualified service personnel.
Operate your device in a place where temperature is between -20 °C and +60 °C.
Operation between -20 °C to -10 °C will result in limited performance.
Charge your device with the recommended charger in a place where temperature is
between 0 °C and +45 °C.
Recommended charging range 0 °C to +30 °C for best charging performance.
The charge level of the battery pack has to be checked at the latest after 1 month if
the battery was built in the device and after 3 months if the battery is not built in, to
prevent deep discharge.
The phone should not be connected to the charger if the battery is not inserted.
Stop using the smartphone if abnormal heat, odor, discoloration, deformation, or
abnormal condition is detected during use, charge, or storage.
Use only soft, clean and dry lint-free cloth to clean your device.
Max. power rating for the Smart-Ex 03 device: 5.4 V 3.0A
The Smart-Ex 03 device supports fast charging via USB PD.
Do not disconnect charger by pulling the cord.
Do not use damaged power cords or plugs.
Do not leave a battery on prolonged charge when not in use.
Do not store the battery for more than 1 month in environments with temperatures
between +35 °C to +60 °C (≤90%RH).
Do not throw battery into fire, it might explode.
Do not soak the battery with liquid like water, tea, coffee etc.
Do not hit, bend, deform or drop the battery.
Do not pierce battery with a sharp object such as a needle, etc.
The battery should not have liquid from electrolyte flowing, but in case the electrolyte
come into contact with eyes, don't rub your eyes. Wash your eyes well with clean
water and go to see a doctor immediately. In case the electrolyte come into contact
with your skin, wash it well with clean water.
Do not externally short-circuit the battery. If externally short-circuited, the battery
may be heated, ignited or broken.
There is a risk of explosion if you replace the battery with an incorrect type.
Only use the correct battery type for this device.
Equipment for use in locations where it is unlikely that children will be present.
6

Publicité

loading

Ce manuel est également adapté pour:

Smart-ex 03 dz2