Erreka GO Manuel D'instructions page 13

A
Mounting on the ground
Prepare a firm base and fasten the barrier with
the elements supplied:
• Expansion bolts
• Flatbars
• Washers
• Spring washers
• Nuts
120
GO: 248
GO PLUS: 272
Changing the spring
S
S
T
(A GO PLUS
right-hand
barrier is shown)
A
180
GO: 348
GO PLUS: 352
P369B

If the spring(s) must be changed, do this before
installing the barrier and arm.
1 Place the arm bracket (S) in vertical position.
2 Loosen the nuts (T) anticlockwise until the spring(s)
lose tension. Completely remove them.
3 Remove the spring(s) by detaching them from the
lower anchor (A).
4 Position the new springs in the same way as the
previous ones.
5 Screw the nuts (T) and balance the barrier as
described below. If there are multiple springs, these
must have the same tension, meaning the nuts (T)
on both springs must be tightened equally.
P369J
Preparing the arm: length and LED strip
Adjusting arm length:
If the arm is not telescopic, cut it to the required length.
If the arm is telescopic, it is not necessary to cut it; simply adjust its
length by inserting more or less of the smaller section into the larger
section.
Adjusting the length of the LED strip:
If the arm has been shortened, the LED strip (L) will be too long. Do not
cut it; insert the excess inside the arm through the end. Cut the excess
from the LED strip's protective cover (P).
P369A
P
L
P369F
13