Publicité
ASSEMBLY / DISASSEMBLY OF THE FOIL
❶
Place your foil on a smooth surface. Install the two SCS inserts with the recommended screws.
❷
Insert the SCS inserts over the holes in the carbon plate.
❸
Slide your foil to the desired setting. Tighten all screws. Your board is ready for use.
For disassembly, do the reverse.
EN
ANY QUESTIONS ? Contact our Team
gong-galaxy.com/aide-contact/
- 26
DEFLATION
❶
To deflate the Board, open the Valve cover and
press the button to turn it down to «deflate.» Do
not be surprised by the air that escapes from the
Valve. Do not deflate your board on the water.
>⃝●
If you're not using a GONG foil, you must completely unscrew your screws.
>⃝●
Note that the SCS inserts are compatible with all GONG foils. If you wish to foil with a different foil brand,
use the 4 individual non-opening inserts delivered with your screw kit.
>⃝●
The rubber wedges are used to lock your setting in order to save time before each session.
GONG-GALAXY.COM
EN
❷
Remove your foil by only slightly unscrewing your
screws to allow the foil to slide towards the front
of the board. Roll up your Board carefully starting
from the back of the Board, pad towards the
inside. Do not tighten too close to the Fin box to
avoid generating tension.
- 27
Publicité
