Components; Setup / Usage - WAGNER 725 POWER STEAMER Guide D'utilisation

COMPONENTS

# PART NO. DESCRIPTION
1
------- Water tank
2 2410370 Filler cap
3
2413475 Steam hose
4
2410388 Large steam plate
5 2413191 Small steam plate

SETUP / USAGE

Prior to filling, the water tank must rest on a
sturdy, level surface and in an upright position.
1.
Remove filler cap and fill the water tank with clean water to
the MAX level line indicator. Replace the fill cap.
2.
Thread the hose ends to the threaded outlets of the water
tank and the steamplate.
3.
Plug in the power cord. It will take approximately 12
minutes for the water tank to produce steam.
A full container will operate for about 2 hours. To refill,
unplug the power cord and let the steamer cool for a
minimum of 2 minutes.
4.
For best results, use a scoring tool or a putty knife and gently
score the wallpaper in a crisscross pattern. The perforations
will allow the steam to penetrate the wallpaper.
5.
Once steam is flowing out of the steam plate, hold the
steam plate flat against the scored wallpaper for about
10 seconds. Move the steam plate to a new section and
remove the steamed section with the scraper blade.
DO NOT OPERATE THE STEAMER ONCE THE
WATER TANK IS EMPTY.
4
1
1
2
3
4
EN
2
3
4
5
1.
2.
12
5
max.