Danby DOM16A2SSDB Manuel D'installation page 6

INSTALLATION INSTRUCTIONS
INSTALLATION
• Remove all packing materials from the inside and outside of the
appliance. Do not remove the cardboard mica sheet covering the
magnetron.
• Check the appliance for damage before using, such as a misaligned
or bent door, damaged door seals, broken or loose door hinges
or latches, or dents inside the cavity or on the door. If there is any
damage to the appliance, do not use it, return it to its point of
purchase or contact consumer care.
• The mounting surface must be capable of supporting the cabinet load
in addition to the added weight of this microwave, approximately
22.6 - 31.7 kg (50 - 70 pounds), plus additional oven loads of up to
22.6 kg (50 pounds) for a total weight of 45.2 - 54.3 kg (100 - 120
pounds).
• This appliance cannot be installed in cabinet arrangements such as
an island or peninsula. It must be mounted to both a top cabinet and
a wall.
• Do not clean this appliance with or use near combustible materials.
• Do not block any ventilation openings on the appliance.
• Do not operate the appliance without the glass tray, roller support
and shaft in their correct positions.
• Make sure the shelf is positioned properly inside the microwave to
prevent damage from arcing. Do not use the microwave with the shelf
on the fl oor of the microwave. Do not use the shelf when cooking
popcorn. Always use pot holders when removing the shelf as it may
be hot.
5