Makita BV4500-118 Manuel D'instruction page 7

CAUTION:
Do not look in the light or see the
source of light directly.
Pull the switch trigger to light up the lamp. The lamp
keeps on lighting while the switch trigger is being pulled.
The lamp goes out approximately 10 seconds after
releasing the switch trigger.
NOTE: When the remaining amount of the battery
becomes low, the lamp blinks a few times. In this
case, charge the battery or replace the battery with a
charged one.
NOTE: Use a dry cloth to wipe the dirt off the lens of
the lamp. Be careful not to scratch the lens of lamp, or
it may lower the illumination.
Electric brake
This tool is equipped with an electric brake. If the tool
consistently fails to quickly stop after the switch trigger
is released, have the tool serviced at a Makita service
center.
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Installing or removing the pulling
unit (nose assembly)
To remove the pulling unit (nose assembly), follow the
steps below.
1. Loosen the nut of the anvil holder, and then
remove the anvil holder.
1
Fig.6
► 1 . Anvil holder 2. Nut
2
2. Loosen nut A and nut B with two wrenches.
Fig.7
► ( 1) Nut A (2) Nut B
NOTICE:
When installing the pulling unit (nose
assembly), tighten nut A firmly at first, and then
tighten nut B firmly.
3. Loosen nut A with a wrench while holding the nose
adapter with another wrench.
1
Fig.8
► ( 1) Nut A (2) Nose adapter
4.
Loosen the collet assembly with a wrench while
holding the joint with another wrench.
1
Fig.9
► 1 . Collet assembly 2. Joint
To install the pulling unit (nose assembly), perform the
removal procedure in reverse. Be sure to tighten the
nuts and collet assembly with two wrenches firmly.
7 ENGLISH
2
1
2
2