TechniSat DIGICLOCK RADIO Manuel D'utilisation page 5

6. Use the same method to set Alarm 2.
Canceling the Daily Alarm
Press the "ALARM OFF" (power off bu‫מּ‬on) bu‫מּ‬on to stop the alarm. The alarm will
operate 24 hours later as per alarm time set.
Cancelling the Alarm
Press the "ALARM 1" or "ALARM 2" bu‫מּ‬ons, until the buzzer and the alarm clock
symbol will not be illuminated. The alarm se‫מּ‬ing is cancelled now.
Se‫מּ‬ing the Clock
1. You must switch off the radio before you set the clock time.
2. Press and hold the "TIME" bu‫מּ‬on until the display begins to blink, and then re-
lease the bu‫מּ‬on.
3. Press the Hour and Minute bu‫מּ‬on to adjust the hour and minute.
4. Press the "TIME SET" bu‫מּ‬on to save time.
Power from the ba‫מּ‬ery is used only for memory backup device
Se‫מּ‬ing the Sleep Time
1. You must switch off the radio before you set the sleep time.
2. Press the Sleep bu‫מּ‬on repeatedly to set the sleep time ( 90, 80, 70, 60, 50, 40,
30, 20, 10 min or OFF ).
Snooze and Alarm Reset
To use the snooze, press the SNOOZE bar when the alarm is sounding. The alarm
will stop temporarily, but will resume sounding aﬞer 9 minutes.
Changing the brightness of the LED display
The device has the ability to change the display brightness. There are two modes:
bright and darker. In order to change the brightness, please press the snooze but-
ton. If you press SNOOZE bu‫מּ‬on again, display brightness returns to its previous
state.
Specification
Frequency Range: FM 87,5 –108 MHz
Power Source: AC 230V ~ 50 Hz/60Hz, 3W
DC 3V (For back-up)
Power Output: 400 mW
Service:
In case of a failure, please contact with your local distributor of TechniSat
products.