TechniSat DIGICLOCK RADIO Manuel D'utilisation page 4

- Do not choose a location in rooms with high humidity, e.g. in the kitchen or
sauna, as condensation may damage the device. The unit is designed for use in dry
and moderate environments and must not be exposed to dripping or splashing
water.
- The unit may only be operated in a horizontal position.
- Do not place any heavy objects on the unit.
- When moving the product from cold to warm, moisture may accumulate inside
the product. In this case, wait about an hour before operating the unit.
- Route the power cord so that no one can trip over it.
- The outlet should be as close to the appliance as possible.
- To connect to the mains, plug the mains plug completely into the socket.
- Use a suitable, easily accessible mains plug and avoid using multiple sockets!
- Do not touch the power cord or plug with wet hands, danger of electric shock!
- In the event of a malfunction or smoke and odour from the housing, immediately
unplug the mains plug from the socket!
- Disconnect the power plug before a storm breaks out.
- If the appliance will not be used for a long period of time, e.g. before the start of
a long journey, unplug it from the mains socket.
- Too high a volume can damage your hearing.
Radio
1. Press the "ON/OFF" bu‫מּ‬on to turn the clock radio on or off.
2. Adjust the "TUNNING" bu‫מּ‬ons to select the desired station.
3. Press the "VOL +" or "VOL -" bu‫מּ‬on to adjust the volume.
4. Press the "PRE/M+" bu‫מּ‬on to store your desired station. The display will show
the "P01" means your station will be saved on the first pre-set. If it displays "P02"
this means the station is saved in the second pre-set.
5. To store the tuned station, press and hold the „PRE/M+" bu‫מּ‬on until the display
shows flashing "P01". Under this condition short press to confirm station to store in
this memory location. "P01" will stop to flash to feedback station is stored. Tuned
another station and long press „PRE/M+" bu‫מּ‬on until the display shows „P02" flas-
hing then short press to confirm. Repeat this procedure until 10 memories are sto-
red.
Please note you can only recall the preset station until you save all 10 stations.
Se‫מּ‬ing the Alarm
1. You must switch off the radio before you set the alarm time.
2. Press and hold the "ALARM 1" or "ALARM 2" bu‫מּ‬on until the Hour display begins
to blink. The Alarm 1 / 2 bu‫מּ‬ons are marked with a alarm sign.
3. Now you can select to wake up by radio or buzzer. The LED with bell logo stands
for wake up to buzzer. The LED with music note logo stands for wake up to radio.
Press "ALARM 1" bu‫מּ‬on to select different wake up modes.
4. You can set the alarm time, aﬞer you select the wake up mode. Press the
"HOUR" to adjust the hour and press "MIN" bu‫מּ‬on to adjust the Minute.
5. Press the "ALARM 1" bu‫מּ‬on now to fix the alarm time.