Peg-Perego Viaggio Shuttle 120 Mode D'emploi page 19

Installing the booster seat in the vehicle
3. IMPORTANT:
The vehicle anchors
and the booster seat
connectors are correctly
coupled when a green
signal appears above the
connectors (fig_a). A red
signal indicates that the
attachments have NOT
been coupled correctly
(fig_b).
4. After attaching the seat,
pull the front handle again
(fig_a) and, at the same
time, push the car seat
towards the vehicle's seat
(fig_b), then release the
handle.
By doing this the release
buttons on the side of the
base will disappear thus
preventing inadvertent
release.
19