Reattaching The Refrigerator Doors - Samsung Rf4267Hawp/Xaa Mode D'emploi

1
2. Disconnect one connector ( 3 ) on the right side
door and one connector ( 4 ) on left side door. To
remove the water coupler from the hinge, twist
and pull it from the hinge. Remove the water line
( 5 ) while pressing the marked part ( 6 ) of the
water line coupler.
If a red clip is on the coupler, it must be
removed before removing the tube.
cAuTION
4
Red clip
(1/4")
5
6
3. Pull and remove the hinge lever ( 7 ) . Remove the
ground screw ( 8 ) attached to the upper left and
right door hinges with a philips screwdriver (+).
Remove the upper left and right door hinges ( 9 ).
7
9
4. Lift the door straight
up to remove.
5. Remove the screw ( 10 ) attached to the lower
All manuals and user guides at all-guides.com
2
REATTAcHING THE REFRIGERATOR
DOORS
To reattach the fridge doors after you have moved the
fridge to its final location, assemble parts in reverse order.
DISASSEMBLE THE FLEx DOOR
3
8
left and right
door hinges
with a philips
10
screwdriver (+).
Remove the 2
hex head bolts
( 11 ) attached
to the lower left
Allen wrench
and right door
hinges with an allen wrench (3/16"). Remove the
lower left and right door hinges ( 12 ).
1. Take out the Flex
Zone ( 1 ) by lifting
it up.
2. Take off the cover
( 2 ) w/harness
with a flat-blade
screwdriver (-).
3. Disconnect the housing
connector.
4. Remove 2 hex head
bolts from sides with
a socket wrench
(10mm).
5. Lift up the Flex door from
the rails.
12
11
1
2
setting up _07