Specifications; Appendix; Legal Notices - Insignia Ns-Lcd15F Guide De L'utilisateur

Insignia NS-LCD15F 15" LCD TV

Appendix

To attach a wall mount bracket to your TV:
1 Remove the four M4 screws holding your TV
to the stand.
2 Secure the wall mount bracket to the back of
your TV using the four M4 screws, as
indicated in the illustration.
75 mm
Attach wall
bracket here
Remove M4 screws

Specifications

• Design and specifications are subject to
change without notice.
Analog standard NTSC, PAL M, PAL N
Channel coverage Air: 2-69
Cable: 1-125
Power source DC 12 V
Power <60 W
consumption <1 W in standby mode
Audio power 2 W + 2 W internal speaker
S-Video input Y:1 V(p-p), 75 ohm, negative sync
C:0.286 V(p-p) (burst signal), 75 ohm
Video/audio input Video:1 V(p-p), 75 ohm, negative sync
Audio:150 mV(rms)
Component input Y:1 V(p-p), 75 ohm, including sync
Pr/Cr:±0.35 V(p-p), 75 ohm
Pb/Cb:±0.35 V(p-p), 75 ohm
Suggested resolutions:1080i, 720p,
480p, 480i
VGA input D-Sub 15-pin terminal
E-EDID compliant
Suggested scan rates:640×480 /60 Hz,
800×600 /60 Hz, 1024×768 /60 Hz
Audio input: Headphone mini-jack for
stereo
M4 screws
75 mm
Remove M4 screws
Remove stand
www.insignia-products.com
Accessories Power cord
Signal cable
Audio cable
AC adapter
User guide
Remote control
Batteries (2 AAA)

Legal notices

FCC Part 15
This equipment has been tested and found to comply
with the limit for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation.
If this equipment does not cause harmful interference
to radio or television reception which can be
determined by turning the equipment off and on, the
user is encourage to try to correct the interference by
one or more of the following measures.
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio or
TV technician for help.
• Only a shielded interface cable should be
used.
Modifications
The FCC requires the user to be notified that any
changes or modifications made to this device that are
not expressly approved by Insignia may void the user's
authority to operate the equipment.
Cables
Connections to this device must be made with shielded
cables with metallic RF/EMI connector hoods to
maintain compliance with FCC Rules and Regulations.
Canadian notice
This Class B digital apparatus meets all requirements
of the Canadian Interference-Causing Equipment
Regulations.
Avis Canadian
Cat apparel numerous de la classed B respected
toutes les exigencies du règlement sur le materiel
brouilleur du Canada.
Copyright
© 2007 Insignia. Insignia and the Insignia logo are
trademarks of Best Buy Enterprise Services, Inc. Other
brands and product names are trademarks or
registered trademarks of their respective holders.
Specifications and features are subject to change
without notice or obligation.
11