Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
HRD 150/160 - 2SGi
Contents
2 General information
3 Safety instructions
6 Required tool and auxiliaries
1 General information and intended use
The HRD 150/160-2SGi press seal is suitable for subsequent installation and for sealing cables in an HSI 150-
K(2) wall insert.
2
General information
•
Any nationally applicable regulations regarding the laying and backfilling of pipework
must be followed!
•
Compact the foundations and cable support well before laying the cables/pipes to prevent
the cables/pipes from sinking.
•
The incorrect laying of cables or ducts and improper filling of the cable trench causes
settlement, which can lead to damage and leaks.
•
Only open cable entries just before fitting with cables to avoid accidental damage during
foundation works.
•
Cables or pipes shall not be under mechanical stress.
Further accessories and information at www.hauff-technik.de and in the technical data
•
sheets
3
•
It is important to protect the press seal from damage and impurities during installation.
Check that all necessary components have been delivered and that they are not damaged.
•
You must not install damaged components.
•
Installation must comply with the relevant professional association regulations, VDE provi-
sions, national safety and accident prevention regulations as well as company regulations
(work and procedural instructions).
•
Do not use solvent-based cleaning agents to clean cable entries. We recommend using KR
M.T.X. cable cleaner (art. no. 0331010100).
Legend
1
Workflow
Important information
7
EN
Publicité
Table des Matières
