Installation - Hauff-Technik HSI150-2SGi Instructions De Montage

HRD 150/160 - 2SGi
Preparing to install the HRD 150/160 - 2SGi:
• Do not open the closing blind cover of the cable entry until just before installing the cable.
• Any cable entries that are not required may be used as pressure-tight back-up entries if
there is an undamaged Hauff quality seal on the closing cover.
• Do not knock the closing cover in with a hammer or sharp object.
• Open cable entries that are to be used as back-up entries or closing covers which have been
opened accidentally should be fitted with new HSI150-D closing covers.
• Do not reuse uninstalled or damaged closing covers.
7

Installation

Remove protective foil from the cable entry (after warming
1
slightly).
If necessary, clean out concrete residue from the wrench
2
threads on the black closing cover.
Use the SLS 6G(D) flexible socket wrench (accessory) to
open the closing cover via the wrench threads by twisting
to the left.
After installing the cable, clean any contamination from
3
the inside of the cable entry and the cable using KR M.T.X.
cable cleaner (accessory), and check the sealing surface
for damage.
9
EN