7.6 Cleaning The Sensors - Philips Fc9910 Mode D'emploi

1
Remove fluff, hairs and other dirt from
5
the roller brush with the comb end of the
cleaning tool or with your fingers.
D
Note:
You can find the cleaning tool on the inside of
the dust container compartment cover (see
section 'Emptying the dust container' in this
chapter).
D
Note:
The roller brush is not dishwasher-proof and
not waterproof.
Reinsert the square pin on the right-hand side
6
of the roller brush into the square hole in the
bearing block (1). Place the other end of the
roller brush in the recess (2).
1
D
Note:
2
You can find the cleaning tool on the inside of
the dust container compartment cover (see
section 'Emptying the dust container' in this
chapter).
Place the roller brush retainer over the roller
7
brush (1) and press the sides of the retainer
home until the latch hooks lock into place
('click') (2).

7.6 Cleaning the sensors

Clean the obstacle detection sensors in the
1
bumper of the robot with a cotton bud.
Clean the floor detection sensors on the
2
bottom of the robot with a cotton bud.
2
1
CLICK
2
25