Publicité
Les langues disponibles
Les langues disponibles
6. The machine dispenses milk first and then coffee.
The preparation process will stop automatically.
NOTE: If you wish to stop your beverage sooner, press
the 'Cappuccino' button again during the operation.
7. Place your stainless steel milk jug in the refrigerator once
you have finished preparing your beverage.
8. After each use, refer to section 5.1.4 Milk accessories to
clean your milk system.
4.6 Preparing your Latte Macchiato
1. Prepare the machine and milk accessories as described in
section 4.4 Assembling the stainless steel milk jug lid and
automatic milk frother
2. Fill the milk jug with milk and close gently the lid to avoid
an in-draft air transfer.
NOTE: Always use cold semi-skimmed or whole milk
(at a temperature of about 5°C) with a protein concentration
of at least 3% to get the best milk foam.
3. Make sure that the external drip tray and its stainless steel
grate are properly positioned and that the water tank is
full. As soon as the machine is switched on, it automatical-
ly rinses itself using approximately the same amount
of water as a small coffee cup.
4. Place a cup under the spout and adjust the height of the
spout according to the type of cup. Depending on the
height of the cup (higher or wider), you can remove or
shift the outer drip tray or adjust the position of the drip
tray as follows:
5. Press the Latte macchiato button
lights up to indicate that the beverage is being prepared.
The Latte macchiato button remains lit, and the light
indicates that the machine is preparing the beverage.
The machine dispenses milk first and then coffee.
The preparation of your milk-based beverages
needs few seconds before the machine is started.
6. The preparation process will stop automatically.
7. Place your stainless steel milk jug in the refrigerator
8. After each use, refer to section 5.1.4 Milk accessories
4.7 Preparing your milk foam
1. Prepare the machine and milk accessories as described in
2. Fill the milk jug with milk and close gently the lid to avoid
(at a temperature of about 5°C) with a protein concentration
3. Make sure that the external drip tray and its stainless
4. Place a cup under the spout and adjust the height of the
, Only the button
WARNING: Steam and hot milk may escape from the nozzle
at the start of the beverage preparation process. Wrap the
milk connection hose around the stainless steel milk jug lid
after use - never leave the hose hanging down.
TIPS: If you wish to stop your beverage sooner, press the
'Latte Macchiato' button again during the operation.
once you have finished preparing your beverage.
to clean your milk system.
section 4.4 Assembling the stainless steel milk jug lid and
automatic milk frother.
an in-draft air transfer.
TIPS: Always use cold semi-skimmed or whole milk
of at least 3% to get the best milk foam.
steel grate are properly positioned and that the water
tank is full. As soon as the machine is switched on, it
automatically rinses itself using approximately the same
amount of water as a small coffee cup.
spout according to the type of cup. Depending on the
height of the cup (higher or wider), you can remove or
shift the outer drip tray or adjust the position of the drip
tray as follows:
29
.
Publicité
