Connecting Speaker Cables; Using Standard Speaker Cables - Yamaha M-5000 Mode D'emploi

Connecting speaker cables

Using standard speaker cables

1
Remove approximately 10 mm (0 4 in) of
insulation from the end of each speaker
cable, and twist the exposed wires
together tightly to prevent short circuits
10 mm (0 4 in)
2
Unscrew the knob on each SPEAKERS
terminal, and then insert the bare wire into
the side hole on the terminal
3
Tighten the knob
16
Diameter of the speaker cable
wire hole: 6 0 mm (0 24 in)
CAUTION
• Do not loosen the knob excessively . Otherwise, the knob
might come off and a child might swallow it accidentally .
• To reduce the risk of electric shock, do not touch the
SPEAKERS terminals while the power to the unit is on .
NOTICE
If the SPEAKERS terminals come into contact with a metallic
rack, a short circuit might occur, resulting in damage to this
unit . When installing the unit in a rack, maintain a sufficient
clearance to prevent the SPEAKERS terminals from coming
into contact with the rack .