Publicité
Les langues disponibles
Les langues disponibles
8785107
Test the tool by plugging it directly to the power supply. If it powers on, change
the extension cord with to one with the correct rating and as short as needed.
You may need to position the workpiece closer to the power supply.
ELECTROMAGNETIC FIELDS
WARNING! Stop welding immediately and move away from the welding unit if
you feel faint, dizzy, nausea or shocks. Seek medical attention.
Electromagnetic Fields (EMF) can interfere with electronic devices such as
pacemakers. Anyone with a pacemaker should consult with their doctor before
working with or near a welding unit. The following steps can minimize the
effects of electromagnetic fields.
1. Twist or tape cables together and prevent coils.
2. Do not drape cables on your body.
3. Keep the welding power source and cables as far away from the user as
practical. A minimum of 24 in. is recommended.
4. Connect the workpiece clamp as close to the weld as possible, but lay the
MIG torch and workpiece cables away from the user.
5. Use the lowest current setting possible during welding.
6. Avoid long and regular bursts of energy while welding. Apply the welding
wire in short strokes and intermittently. This will prevent the pacemaker
from interpreting the signal as a rapid heartbeat.
7. Keep the lead cable and ground cables on the same side of your body.
8. Do not weld while carrying the welding power source.
9. Do not work next to, sit or lean on the welding power source.
UNPACKING
WARNING! Do not operate the tool if any part is missing. Replace the
missing part before operating. Failure to do so could result in a malfunction
and personal injury.
Remove the parts and accessories from the packaging and inspect for damage.
Make sure that all items in the contents are included.
Contents:
• Welding Machine • MIG Torch
• Brush/Hammer
16
130A Inverter MIG Welder
• Contact Tips
For technical questions call 1-800-665-8685
• Ground Lead with Clamp
V4.0
Publicité
