Midea WCPPHA06CRA Manuel Utilisateur page 23

REMOTE CONTROL INSTRUCTIONS
Cooling /Fan only operation
CLOCK SET TEMP.
FAN SPEED
1
2
DRYING OPERATION
CLOCK SET TEMP.
FAN SPEED
3
1
2
Start
Ensure unit is plugged and power is available.
The OPERATION lamp on the display panel of
the indoor unit starts flashing.
1. Mode select button (MODE)
Press to select COOL, FAN ONLY
2. TEMP/TIME button
Set the desired temperature, the most comfortable
4
temperature is between 21 C/70 F to 2 8 C/83 F.
3
3. Fan speed button (FAN SPEED)
Press to select "AUTO" "LOW", "MED" and "HIGH"
4. ON/OFF button
When the remote controller is off, push this
button to start the air conditioner.
Stop
ON/OFF button
Push this button again to stop the air conditioner.
The FAN ONLY mode does not control temperature.
Therefore, perform only steps 1,3, and 4 to select
this mode.
Start
Ensure unit is plugged and power is available.
The OPERATION indicator on the display panel
of the indoor unit starts flashing.
1. Mode select button (MODE)
Press to select DRY.
2. ON/OFF button
When the remote controller is off, push this
button to start the air conditioner.
Stop
ON/OFF button
Push this button again to stop the air conditioner.
Note: The fan speed cannot be adjusted when
the unit is in AUTO and DRY mode.
2 2
。 。
O