Water Inlet Hoses - Whirlpool W11339488B Guide D'utilisation

REMOVING THE DISPENSER (cont.)
Single-Load Dispenser Drawer
Removing the Dispenser
To remove:
1. Pull dispenser drawer out until it stops.
2. Press down on the release tab and pull straight out
to remove the dispenser.
3. Lift off cover panel
by pulling straight up.
To replace:
1. Position cover panel back
onto posts on dispenser.
Apply slight pressure on
cover panel to seat it.
2. Align edges of dispenser
with guides in washer;
then slide dispenser
back into slot.
18
CLEANING LOAD & GO
It is recommended that you rinse out the Load & Go
containers when refilling, when changing detergent types or
concentrations, or when the washer will not be used for an
extended period.
1. Pull the dispenser drawer out until it stops.
2. Lift out the Load & Go
™
3. Lift the fill lid and flush interior thoroughly with warm water.
4. Allow to air dry.
IMPORTANT: Containers are not dishwasher safe.

WATER INLET HOSES

Replace inlet hoses after five years of use to reduce the risk
of hose failure. Periodically inspect and replace inlet hoses
if bulges, kinks, cuts, wear, or leaks are found.
When replacing your inlet hoses:
Mark the date of replacement on the label with a permanent
marker.
Check that the old washers are not stuck on the washer inlet
valves.
Use new washers in the new inlet hoses to ensure a proper seal.
CONTAINERS
™
™
containers.