Uline H-4954 Mode D'emploi

H-4954, H-4955, H-6337
π
H-6338, H-6339
INDUSTRIAL CURTAIN WALLS
TOOL NEEDED
3/16" Allen Wrench
48" Straight Track x 3
Universal Mounting Bracket x 4
Before you begin, determine method of mounting:
ceiling, wall or suspended.
1. The universal
mounting brackets
(with the ceiling
support connector
attached) can
be used for either
wall mounting
or suspended
mounting.
Suspended
mounting requires
3/8" threaded rod
(not included). (See Figure 1)
2. If you are ceiling mounting, use the ceiling support
connectors only.
IMPORTANT! While installing the hardware, add
3" to the height stated on the curtain tag.
SINGLE TRACK
1. Affix an end stop to just one
open end. (See Figure 2)
PAGE 1 OF 9
Ceiling Support Connector x 4
Nylon Roller with Hook x 14
GETTING STARTED
Figure 1
SUSPENDED
MOUNT
Threaded
Rods
WALL
Universal
MOUNT
Mounting
Bracket
CEILING
MOUNT
Ceiling
Support
Connector
Figure 2
1-800-295-5510
uline.com
PARTS
Straight Splice Connector x 2
End Stop x 2
SPLICING MULTIPLE TRACKS
TOGETHER
1. Turn two Allen screws one and a
half turns onto each straight splice
connector. (See Figure 3)
2. Insert the two tracks and tighten the screws. Repeat this
process until all pieces of track are spliced together.
3. Affix an End Stop to just one open end. (See Figure 4)
Figure 4
End Stop
NOTE: Whether you are mounting a single
piece of track or multiple pieces that you
have spliced together, you should place the
universal mounting brackets approximately
6" from each end and either side of a straight
splice connector. (See Figure 5)
Figure 5
6''
Para Español, vea páginas 4-6.
Pour le français, consulter les pages 7-9.
Industrial Curtain x 1
Figure 3
6''
0623 IH-4954
6''