Uline H-4774 Mode D'emploi

H-4774, H-4776
H-5060
SLATWALL PANELS
TOOLS RECOMMENDED
24" Level Tape Measure
Circular Saw
(cordless or corded)
1½" to 2" Drywall Screws
• Always wear safety glasses when using any
power tool.
• Always use hearing protection when using loud
equipment.
• Do not sit, climb, hang or step on shelves or
brackets.
• Do not overload shelves or brackets.
STACKING PANELS
To allow temperature and humidity to equalize, stack
panels at least three-high in work area. Do not stack
directly on concrete floor.
METAL STUDS
Wood screws do not hold well in metal studs. Use
wooden blocking whenever necessary.
PAGE 1 OF 6
1-800-295-5510
uline.com
Drill Pencil
PARTS NEEDED
Roundhead Screws for
Metal Inserts (optional)
GENERAL INFORMATION
Chalk Line
Panel Adhesive
SAFETY
• Do not try to install slatwall panels alone.
Use two people.
• CAPACITY:
40 lbs. without metal inserts.
90 lbs. with metal inserts.
NOTE: Weight capacity will be slightly reduced
for shelves deeper than 10".
BLOCK OR CONCRETE WALLS
First mount vertical or horizontal furring strips on wall.
Installing slatwall directly on concrete or block walls is
not recommended.
ALIGNMENT
Installation label on back of panel displays best "factory
edge." (See page 2) When stacking slatwall higher than 4',
ensure edges line up for proper panel alignment.
Para Español, vea páginas 3-4.
Pour le français, consulter les pages 5-6.
NOTE: Ensure screw heads fit
easily into grooves.
0724 IH-4774