Uline H-1930 Mode D'emploi

H-1930
3M HAND-MASKER
DISPENSER
1. Determine the width of the masking tape to be used.
Select the hole on the blade that matches the tape
width. (See Figure 1)
2"
Figure 1
2. Position the blade locking-pin in line with the blade
hole and press, locking it onto the pin. (See Figure 2)
CAUTION! Serrated edge is sharp. Avoid direct
contact when replacing the blade.
Figure 2
3. To remove blade, press firmly on either side of the
blade locking-pin. (See Figure 3)
Figure 3
PAGE 1 OF 6
1-800-295-5510
uline.com
1½"
1"
3/4"
SETUP
4. Load roll onto dispenser. (See Figure 4)
NOTE: Ensure end of roll faces blade.
5. Load tape onto dispenser. (See Figure 5)
NOTE: Ensure end of tape faces blade.
Para Español, vea páginas 3-4.
Pour le français, consulter la pages 5-6.
Figure 4
Figure 5
0824 IH-1930