Uline H-1036 Mode D'emploi

π
H-1036
ELECTRONIC KRAFT
TAPE DISPENSER
IMPORTANT!
Read these instructions thoroughly and
familiarize yourself with all controls and
operating features. Keep for future reference
and maintenance.
Unpacking: Check the machine for damage. If
damage is found, return to Uline.
CAUTION! Only trained personnel should be
allowed to operate or service this machine.
WARNING! Burn Danger – Switch off power,
unplug the dispenser and allow the top heater
to cool down before performing any cleaning,
maintenance or repair.
PAGE 1 OF 20
1-800-295-5510
uline.com
TECHNICAL DATA
Overall Dimensions
Weight of Machine
Voltage and Frequency
Control Circuit in DC
Electrical Power
Dispensing Velocity
Length
Sound Measured in a Room
TAPE
Types of gummed tape: All
17¾ x 11½ x 9¾"
26½ lbs.
See Machine Label
115 Volts
100W
2.5 ft. or 30" / sec.
Min. 4" / Max. 46"
> 70 dB (A)
PAPER FEATURES
Width: min. 3/4" / max. 4"
Maximum roll diameter: 7¾"
SAFETY
Follow all safety and operating instructions contained in
this manual. Check state and local safety and
electrical codes.
NOTE: Tape dispenser is for use with gummed
tape ONLY. Uline accepts no responsibility for
damage due to improper use.
Check Voltage – Verify that machine voltage and power
supply voltage are the same before plugging in
the dispenser.
Keep the machine clean, dry and in good operating
condition. Do not place or operate machine in damp or
humid environments.
Para Español, vea páginas 7-13.
Pour le français, consulter les pages 14-20.
0122 IH-1036