Kichler 56 ICON CEILING FAN Manuel D'instructions page 21

PROGRAMMING INSTRUCTIONS
System programming: Read all of these steps before proceeding.
Each step must be followed exactly to properly program the control system.
1. You can leave the frequency switches at the factory setting or move them to any combination of up or
down. Use a small flat bladed screwdriver to move the switches.
2. Test the transmitter by pushing and releasing ANY button briefly. A Blue Light should illuminate
under the 3-4 buttons. (Fig. 23) If not, check to make sure the batteries are inserted and seated
correctly.
Power Up and Programming:
3. Follow the below steps to set the remote control:
The auto learning function will only mandate within 60 seconds when turning the fan's AC power ON.
(Figure 24)
4. Select desired frequency from the back of transmitter.
5. Restore power to your fan.
6. Press and hold the " " button for at least 5 seconds (you must press the " " button within 60
seconds of restoring power to the fan).
w7. Your CoolTouch™ Control System is now programmed and ready for use. Please see the Operating
Instructions.
The receiver provides the following protective function:
1. Lock position: The DC motor has a built-in safety against obstruction during operation. If there is an
obstruction, the motor will stop and then the power will automatically go off in 30 seconds. Remove
the obstruction and reset.
2. Over 80W protection: When the receiver detects motor power consumption which is greater than
80W, the receiver power will be stopped and operation will immediately discontinue. Wait for 5 seconds
and then turn the receiver power back on.
Blue Light
Press/hold Button
Fig. 23
Fig. 24
21
56" ICON |