Humanscale efloat go Instructions De Montage page 9

5
Using the (8) M6x14 Machine Screws secure the feet to the legs.
6
Using the (2) ST5 X 20 Screws align the control box with the pilot holes included if using a
Humanscale Worksurface. Alternatively, place the Control Box at your desired location on the
worksurface, ensuring it is within reach of the cable from one of the legs.
7
Secure the Hand Switch to the worksurface in your desired location using the (2) ST4 X 16, screw
along the front edge of worksurface. If using a Humanscale Universal Worksurface, Pilot holes are
positioned on the left/right hand side of the worksurface in our recommended location(s).
9