Humanscale efloat go Instructions De Montage page 6

Assembly Instructions
1
Secure the (10) Adhesive Pads to the (2) Brackets.
2
Using the (8) M6 x 10 Machine Screws secure the brackets to each leg, using the 4mm Allen Key.
3
Place your worksurface upside down on a protective surface. Lift and place the legs on top of the
worksurface. Position the legs on the worksurface per the following sections:
A - Humanscale Worksurface
B - Using Your Own Work-surface.
A - Humanscale Worksurface
Align the legs to the following pilot holes highlighted below. Note: Only the four outer corner pilot
holes are included for alignment. Worksurfaces come with different pilot hole options depending on the
size ordered.
Legend
eFloat Go Base (Beamless)
eFloat Go Hand Switch
Keyboard Tray
6
NeatTech (30" Deep Worksurfaces only)
Not applicable with this table