Humanscale efloat go Instructions De Montage page 10

8
Plug the Hand Switch into the Control Box. Connect the two legs to the Control Box, using the
connecting cable for the leg furthest away from the Control Box. Plug the Power Cord into the
Control Box. Use the provided Cable Ties to secure cables to underside of worksurface (not
pictured), with either double sided tape or the (10) ST5 X 20 Wood Screws.
9
Flip your table right side up and plug into outlet. Reset the desk per instructions in following
section.
YOU MUST RESET THE DESK BEFORE USE. FOLLOW INSTRUCTIONS ON INITIAL SETUP/RESET
10
UNDER HAND SWITCH